PARACORD 101: A Beginner’s Guide to Paracord Bracelets and Projects (8 page)

Continue the weave to the end of the bracelet.

Detach the bracelet and pull the charcoal grey, right,
paracord through the two cord core with forceps. This is done to keep the
Piranha Weave pattern on the top of the bracelet.

To secure the paracord into place, loop both ends through
the main loop and tighten.

Before the bracelet is finished, make sure it fits. If not,
get out the needle nose pliers, take it apart, readjust the paracord jig, and
start again.

If it does fit, estimate 3/4 of an inch from the main loop,
cut, melt and smash.